Now that electronic cigarettes are becoming more and more popular, they will bring atmosphere wherever they go. If you accidentally put your e-cigarette in the water while vaping, don’t worry, there is always a way to bring your e-cigarette back to life.
First of all, if your electronic cigarette accidentally enters or falls into water, please take out the electronic cigarette immediately, and reduce the moisture content of the cigarette rod as much as possible, because the liquid on the circuit board will cause the electrical conductors to connect to each other and cause a short circuit, resulting in A short circuit, and a short circuit will directly burn the entire circuit.
1. First separate the pod from the fuselage
Of course, once our electronic cigarette enters the water, the first thing is to salvage it immediately. Immediately separate the e-cigarette bomb from the plume. Stop bringing the electrodes into contact with each other again.
2. Dry the electronic cigarette stick
After the first step, immediately understand how vaping sticks absorb moisture. If you have a hair dryer at home, you can use a hair dryer to dry the moisture in the tobacco rod, but pay attention: you must use cold air and remember not to use hot air. The circuit board may be blown to pieces by the hot air. If you don’t have a hair dryer, try using paper towels and hand-drying the rod. After drying, let the stem sit for a few minutes until the stem is completely dry before proceeding to the next step.
3. Check whether the smoke rod has any effect
After completing the above steps, the next step is to check whether the smoke rod is broken. After making sure the rod is completely dry, put the cartridge back on the rod. Note the change in the indicator light. Generally, the indicator light of the pod is white. If placed in a pod, it will turn red. This is where the glitch problem lies. Then try pumping water again, if it is a white bulb and pumping water, there is no problem. If the bulb turns red and cannot be smoked, it means that the circuit board in the device may be short-circuited by water. If the pipe is really damaged by water ingress, none of these methods can handle it well, and you can find a local after-sales service.